IMAP and IMAPS Authentication are supported natively in tikiwiki, and can be configured as shown below:
NOTE: As of TikiWiki 3.0 these instructions are no longer valid. Only LDAP is supported under 3.0.
IMAP Authentication
-
Browse to Admin, Login, User registration and login
- set "Authentication Method" to Tiki and PEAR::Auth
- Click "Change preferences" at the bottom of the "User registration and login" section
-
Browse to Admin, Login, PEAR::Auth
- set "Auth Type" to IMAP
- Set "IMAP/POP3/LDAP Host" to be the IP address or hostname of your IMAP server
- Set "IMAP/POP3/LDAP Port" to 143
- Click "Change preferences"
Done!
IMAPS Authentication
Customizations required for IMAPS/SSL Support highlighted in green below.
-
Browse to Admin, Login, User registration and login
- set "Authentication Method" to Tiki and PEAR::Auth
- Click "Change preferences" at the bottom of the section
-
Browse to Admin, Login, PEAR::Auth
- set "Auth Type" to IMAP
- Set "IMAP/POP3/LDAP Host" to be the IP address or hostname of your IMAP server
- Set "IMAP/POP3/LDAP Port" to __993__
- If your IMAPS certificate is signed by a well-known Certificate Authority:
- Set "IMAP/POP3 BaseDSN" to __/imap/ssl__
- If your IMAPS certificate is self-signed, or if the above setting does not work:
- Set "IMAP/POP3 BaseDSN" to __/imap/ssl/novalidate-cert__
-
Click "Change preferences" at the bottom of the section
This page is a stub
Documentation needed.
Copy/paste from mailing list:
"On your page, in authentication, you are missing IMAP(S), it is a very good and simpler way to authenticate than LDAP. I just implemented it. It uses the same PEAR:Auth library."